Premium door PIVOT–45, milling, natural veneer

A new model(brand new model) from UNION is a pivot door PIVOT–45 without a door frame. The canvas is 45 mm thick with an  aluminum edge.
– Model: Step – with linear vertical milling on natural veneer. The direction of the veneer pattern corresponds to the milling direction.
– Model: Bolla – relief, structural pattern on natural veneer Noce Canaletto, the direction of the veneer pattern is only horizontal.
The aluminum profile is available in any of 9 possible finishes.

– Door leaf 45 mm. Engineering construction, frame made of double timber of multilayer solid wood + two HDF panels.
– Options for fabric finishes: Veneer – natural veneer. matt lacquer.
– Aluminum edge – additional protection and aesthetics.
– When the door height is more than 240 cm, the special compensation rod for correcting possible bending  is mounted  inside of the canvas.
– The aluminum edge and handle can be in any of the finishes offered by the manufacturer.
– Hidden reinforced pivoting hinges.
– Maximum dimensions: width up to 120 cm, height up to 300 cm (for Step–V model).
– Maximum dimensions: width up to 90 cm, height up to 240 cm (for the Bolla model).

1. Measure the necessary dimensions of a doorway L2/H2 (width, height). For standard door sizes a discount is provided.
2. Plaster the walls vertically (without deflections). Prepare the walls for the final finishing.
3. The door is installed on the same level as a finishing floor. Make sure your floor is finished or you have a mark of a final floor level.  The floor must be flat, without weirs.